Temptronic ThermoStream TP04100A Interface & Applications Manual

Rev A: 0611 5/98
A" TEWlWNE YRPORATICN
General Data
TP04100A Interface & Applications
. .
1-5 System Software: Local and Remote Operation
1-5.1 Local Operation
The System's operating program is loaded internally at the factory into programmed devices. Concerning
software, refer to the Copyright Statement on back of the Title (Front) page. To operate the system in Program
Operation Mode, see Section 3 of this manual. To operate the system in Manual Operation Mode, see the
TP04100A Operator's Manual.
1-5.2 Remote Operation: TherrnoCornm Software (Optional)
The System provides three 110's for three different communication interfaces: Serial (RS232C), Parallel Bus
(GPIB) (IEEE-488.2), and STEOTISFF Interface.
A summary of the three 110's (and also of ThermoComm
Software, mentioned below) is given in Section 2, "Remote Control Communications." See Section 4,
"Remote Interfaces" for detailed instructions and command sets.
ThermoComm Software (optional) is a Windows 3.1195198lNT application which enables:
Remote control of Temptronic equipment
Unattended logging of test data, and
Subsequent analysis of test data
It is suggested the end user first verifjr proper system operation in local mode before attempting to use remote
control programs developed by the end user.
Page 1-5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Temptronic ThermoStream TP04100A Specifications

General

Brand	Temptronic
Model	ThermoStream TP04100A
Category	Industrial Equipment
Language	English