Temptronic ThermoStream TP04100A - 2-19.1 Main Power Switch; Initial Start-Up, Check Out, Shut down; Initial Start.up, Check Out, Shut $Own

Preparation for Use
TP04100A Interface & Applications
Rev A: 0611
5/98
2-19 Initial Start-up, Check Out, Shut
Down
/"\
,/q-"',
v
TEMPTRONIC
CORPORATION
The following procedure outlines initial startup and check out for the TP04100A system, and how to shut
down after the system has been operated.
Once the TP04100A is started and you are satisfied that the system works properly, see the following:
For local, Program Mode operation, see Section 3, "System Operation," in this manual
For local, Manual Mode operation, see the
TP04100A Operator's Manual
For remote, IEEE-488.2 or RS232C operation, see Section 4, "Remote Interfaces," in this
manual
2-19.1 Main Power Switch
MAIN POWER SWITCH --\
POWER INDICATOR LAMP 3
, sal
Figure 2-15 Main Power Switch
Page 2-40 41 IA-S2F.doc
Figure 2-13 shows the Main Power Switch, located on the right hand side of the controller's front panel. This
switch also serves as the primary
- (ac) power circuit breaker (CB 1) for the system. An IEC 320 connector
for receiving the input power cord is located on the rear panel of the controller. Note the Power (onloff)
Indicator Lamp located below the Main Power Switch. Allow several seconds for the Lamp to light after
activating the Main Power Switch.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com