Preparation
for
Use
TP04100A Interface
&
Applications
Rev A: 0611
5/98
"
TEMPTRONIC
CORPORATIGN
With the user supplied tubing, connect the compressed air source to the
FilterRegulator air input. With the nylon tubing (supplied,
P/N
VV02400), connect the FilterRegulator
output to the Controller air input (SPI). Use appropriate hose clamps to secure each hose end between
the compressed air source and the FilteriRegulator.
NOTE:
Refer to the "Specifications" data sheet included in Section
1
for the compressed air
requirements.
Turn on the compressed air supply to the FilterRegulator.
Set the regulator on the Filter/Regulator for a reading of 80 psi on its pressure gauge.
Page
2-22
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
