TESTO 400 - Reading the IAQ Data Logger

14 IAQ data logger
131

IAQ data logger is configured.

Following successful configuration, the testo 400 can be disconnected
from the IAQ data logger. The measurement starts at the defined time
or as soon as the setup has been completed (if the start time has been
set to manual). The green LED on the IAQ data logger flashes rapidly
at short intervals.
14.7 Reading the IAQ data logger
Since the IAQ data logger is a standalone instrument, the testo 400 can
be used for other measuring tasks following configuration of the IAQ
data logger, while the measurement is ongoing.
The time for storing the measurement data can easily be delayed if the
measurement involves a huge amount of data.