TESTO 400 - Damping

9 Operation
85
9.7.5 Damping
If the readings fluctuate wildly, it is advisable to damp the readings.

The probe is connected to the testo 400.
1
Click on .

Main menu opens.
2
Click on Sensors.

The Sensors menu opens.
3
Click on the required sensor.

Information is displayed about the model, order number, serial number
and firmware version.
4
Click on the Measurement parameters tab.

Window with measurement parameters opens.
5
Enable Activate damping using the slider.
6
Click on Average of the measured values.

Window for Average of the measured values opens.
7
Enter a value between 2 and 20 seconds.