TESTO 400 - Setting up an E-Mail Account; Tutorial; Connecting Probes; Connecting a Cable Probe to the Testo 400

8 Commissioning
20
of the measurement. The new company details will only be stored in the PDF
report once a new measurement is carried out. Please also see Section 10.3.4.
8.4.6 Setting up an e-mail account
Click on the E-mail field to connect an e-mail account to the testo 400
measuring instrument, so that you can send measurement data reports via e-
mail. See also Section 10.2.
8.5 Tutorial
At the end of the Setup wizard, the tutorial can be launched.
The tutorial can be executed again at any time via the Help and
Information menu.
The tutorial demonstrates the general operation and the most important
functions of the measuring instrument, using brief examples. The detailed
descriptions can be found in the relevant sections.
• Connect cable and Bluetooth
®
probes (see Section 8.6)
• Display - user interface (see Section 9.1)
• Application menus (see Section 9.4)
• General measurement information (see Section 9.3.1)
• Managing measurement data (see Section 9.6.1)
• Customer management (see Section 9.5)
• Sensor management (see Section 9.7)
• Setting up an e-mail account (see Section 10.2)
8.6 Connecting probes
All probes can be connected or changed while the instrument is
switched on. However, the connection must not be interrupted during a
probe update.
8.6.1 Connecting a cable probe to the testo 400
>
Connect the testo 400 to the probe via the TUC slot.

The cable probe is immediately displayed in the sensor management,
in the basic view and in the relevant measurement menu.