EN - 18
6 Setting up the power supply EX-TRAFIRE
®
45HD
6.4 Connecting the input power plug
Note the safety instructions.
2.5 Safety instructions for the electrical power supply on page EN-7
For the input voltage and the fuse protection, please refer to:
4.2 Technical data on page EN-11
If necessary, have a qualified electrician connect the input power cable
extension in accordance with local regulations.
Ensure that the power supply is adequately protected by a safety switch.
Insert the input power plug of the input power cable into the
corresponding socket.
Electric shock due to improperly installed electrical power supply
If the electrical power supply and grounding are improperly installed,
fatal electric shock may occur.
• If you want to operate the device in a very humid environment or on
conductive material, install a ground fault circuit interrupter (GFCI) in
the power supply.
• Use a slow-blow GFCI fuse.
• Protect the power supply line to the device with suitable fuses that
comply with regulations.
• Ground the device according to the applicable regulations.
• Do not ground the device together with other devices or machines.
Risk of electric shock due to improperly installed or defective cables
Damaged or improperly installed cables can lead to fatal electric shock.
• Check all live cables and connections for proper installation and
damage.
• Damaged, deformed or worn parts should only be replaced by a
qualified electrician.
Risk of injury due to fire
Improper use or connection can result in fire. This may result in serious
injury.
Ensure that the operating voltage specified on the identification plate
is suitable for the input voltage.
To Next Page
Loading...
