EN - 6
2Safety EX-TRAFIRE
®
45HD
2.2 Obligations of the operator
Ensure that only qualified personnel are permitted to work on the
device or system.
Authorized personnel are:
— those who are familiar with the basic regulations on occupational
safety and accident prevention;
— those who have been instructed on how to handle the device;
— those who have read and understood these operating instructions;
— those who have been trained accordingly;
— those who are able to recognize possible risks because of their
special training, knowledge, and experience.
Keep untrained persons out of the work area.
Each time the device’s cover plates are opened, have Thermacut
®
or
another authorized specialist perform a safety inspection in accordance
with DIN IEC 60974 Part 4: “Periodic inspection and testing”.
The device can produce electromagnetic fields that could impact the
proper function of cardiac pacemakers and implanted defibrillators.
Do not use the device if you have a pacemaker or an implanted
defibrillator.
This Class A cutting device is not intended for use in residential areas with
a public low-voltage power supply system. It can potentially be difficult to
guarantee electromagnetic compatibility in these areas due to both
conducted and emitted interference.
The device may be used only in industrial zones according to
DIN EN 61000-6-3.
2.3 Warning and notice signs
The following warning, notice and mandatory signs can be found on the
product:
These markings must always be legible. They may not be covered,
obscured, painted over, or removed.
2.4 Product-specific safety instructions
Do not use or store the device outdoors where it is wet.
Do not operate the device if the housing is open.
Read and observe the operating instructions.
To Next Page
Loading...
