THERMACUT EX-TRAFIRE 45HD - Setting the DIP Switches; Enabling the External DC Coil with an External Power Supply

EX-TRAFIRE
®
45HD 6 Setting up the power supply
EN - 21
6.6.1 Setting the DIP switches
The DIP switches are preset to 50:1.
1 The housing must be opened only by a qualified electrician.
2 The DIP switches must be set only by a qualified electrician.
 Fig. 5 DIP switch settings on page EN-21
3 The housing must be closed only by a qualified electrician.
4 Have a safety inspection performed in accordance with DIN IEC 60974
Part 4: “Periodic inspection and testing” by Thermacut
®
or another
authorized specialist.
6.6.2 Enabling the external DC coil with an external power supply
 For 24 V DC, use a 1N4007 diode.
Fig. 5 DIP switch settings
Fig. 6 Enable the external DC coil with an external power supply.
24 V DC
Use diode
1N4007 if the
voltage is
24 V DC.