THERMACUT EX-TRAFIRE 45HD - Table of Contents

EN - 2
EX-TRAFIRE
®
45HD
Table of contents
1 Identification ............................................................... EN-4
1.1 Marking.............................................................................................. EN-4
1.2 Identification plate ........................................................................... EN-4
1.3 Signs and symbols used.................................................................. EN-4
1.4 Classification of the warnings......................................................... EN-5
2 Safety........................................................................... EN-5
2.1 Designated use................................................................................. EN-5
2.2 Obligations of the operator............................................................ EN-6
2.3 Warning and notice signs................................................................ EN-6
2.4 Product-specific safety instructions................................................ EN-6
2.5 Safety instructions for the electrical power supply ...................... EN-7
2.6 Safety instructions for plasma cutting............................................ EN-7
2.7 Personal protective equipment ...................................................... EN-7
2.8 Emergency information................................................................... EN-7
3 Scope of delivery......................................................... EN-8
4 Product description ..................................................... EN-9
4.1 Assembly and use ............................................................................ EN-9
4.2 Technical data................................................................................. EN-11
4.2.1 EX-TRAFIRE
®
45HD, Single-phase................................................. EN-11
4.2.2 EX-TRAFIRE
®
45HD, Three-phase.................................................. EN-12
4.3 Technical data for cutting torches FHT-EX
®
45TTH
and FHT-EX
®
45TTM ....................................................................... EN-13
5 Transport and positioning .........................................EN-15
6 Setting up the power supply .....................................EN-16
6.1 Connecting to the gas supply....................................................... EN-16
6.2 Connecting the work lead............................................................. EN-16
6.3 Connecting the power supply cable ........................................... EN-17
6.3.1 Connecting the single-phase machine........................................ EN-17
6.3.2 Connecting the three-phase machine......................................... EN-17
6.4 Connecting the input power plug................................................ EN-18
6.4.1 Connection to a generator (optional).......................................... EN-19
6.5 Connecting the cutting torch........................................................ EN-19
6.6 Connecting the CNC interface ..................................................... EN-20
6.6.1 Setting the DIP switches................................................................ EN-21
6.6.2 Enabling the external DC coil with an external power supply . EN-21
6.6.3 Enabling the external AC coil with an external power supply.. EN-22
6.6.4 Enabling the industrially insulated module with an
external power supply................................................................... EN-22
6.7 Installing consumables for the hand and machine
cutting torches................................................................................ EN-23
6.8 Aligning FHT-EX
®
45TTM machine cutting torch ........................ EN-25
7 Operation of the power supply .................................EN-25
7.1 LCD description.............................................................................. EN-26
7.1.1 Setting the parameters.................................................................. EN-27
7.1.2 Selecting the cutting mode........................................................... EN-28
7.1.3 Connecting the work lead with the work lead clamp................ EN-28
7.2 Powering on the machine ............................................................. EN-29
7.3 Manual cutting process ................................................................. EN-29