EX-TRAFIRE
®
45HD 2Safety
EN - 7
2.5 Safety instructions for the electrical power supply
Ensure that the input power cable is not damaged, for example by
being driven over, crushed or torn.
Check the input power cable for damage and wear at regular intervals.
If it is necessary to replace the input power cable, only models indicated
by the manufacturer may be used.
Only a qualified electrician should carry out work on the input power
cable and the input power plug.
Water protection and mechanical stability must be ensured when
replacing the input power plug of the input power cable.
2.6 Safety instructions for plasma cutting
Plasma cutting may cause damage to the eyes, skin, and hearing. Note
that other hazards may arise when the device is used with other cutting
components. Therefore, always wear the prescribed personal protective
equipment as defined by local regulations.
All metal vapors, especially lead, cadmium, copper, and beryllium, are
harmful. Ensure sufficient ventilation or extraction. Do not exceed the
current occupational exposure limits (OEL).
To prevent the formation of phosgene gas, rinse workpieces that have
been degreased with chlorinated solvents using clean water. Do not
place degreasing baths containing chlorine in the vicinity of the cutting
area.
Adhere to the general fire protection regulations and remove
flammable materials from the vicinity of the cutting work area prior to
starting work. Provide appropriate fire extinguishing equipment in the
workplace.
2.7 Personal protective equipment
Wear your personal protective equipment (PPE).
Ensure that others in close proximity are also wearing personal
protective equipment.
Personal protective equipment consists of protective clothing, safety
goggles, face protection, ear protectors, protective gloves, and safety
shoes.
2.8 Emergency information
In the event of an emergency, immediately disconnect the following
supplies:
— Electrical power supply
—Gas supply
To Next Page
Loading...
