EX-TRAFIRE
®
45HD 2Safety
EN - 5
1.4 Classification of the warnings
The warnings are divided into four different categories and are indicated
prior to potentially dangerous work steps. The following signal words are
used depending on the type of hazard:
2 Safety
This chapter warns of residual hazards that should be kept in mind to
operate the product safely. Non-observance of the safety instructions may
result in risks to the life and health of personnel, environmental damage or
material damage.
Observe the document entitled “Safety Instructions”.
2.1 Designated use
The device described in this document may be used only for the purpose
and in the manner described. The device is used only for the generation
and control of the output current required for plasma cutting, gouging, and
marking. Any other use is considered improper. Unauthorized
modifications or changes to enhance the performance are not permitted.
Do not exceed the maximum load data as defined by the document
supplied. Overloads lead to destruction.
Do not make any modifications or changes to this product.
Do not use the device to thaw pipes.
Do not use or store the device outdoors where it is wet.
Describes an imminent threatening danger. If not avoided, it may cause
severe injury or death.
Describes a potentially dangerous situation. If not avoided, this may
result in serious injury or death
Describes a potentially harmful situation. If not avoided, this may result in
slight or minor injury.
Describes the risk of impairing work results or material damage and
indicates irreparable damage to the device or equipment.
To Next Page
Loading...
