Toa RM-200M - Page 53

53
5
:
SETT I N G DATA
C
O MM UN I CAT I O N
51
:
SETT I N G DATA
PC
–>
V
M
–
3000
52
:
SETT I N G DATA
V
M
–
3000
–>
PC
RECE I V I N G TRANS M ITTIN G
OK
OK
MENU
OK
Set data transmission
Transmission from PC to
VM-3240VA
1
3
Transmission from VM-3240VA
to PC
3
2
[Transmission of PC-set data]
Transmit data set by a PC to the VM-3240VA from the PC or conversely from the VM-3240VA to the PC.
Step 1. Press the OK key on the Set Data
Transmission screen.
The screen for selecting the transmission
source and transmission destination is
displayed.
Note
Pressing the Cancel key returns the
display to the original screen.
Step 2. Press the Menu key to switch the source
and destination.
Step 3. Press the OK key.
The "RECEIVING" or "TRANSMITTING"
indication is displayed on the screen.
Step 4. Activate the setting software to transmit set data from the VM-3240VA to the PC or from the PC to the
VM-3240VA. Click "Communication" on the menu bar and select "Setting Data: VA->PC" or "Setting
Data: PC->VA" on the pull-down menu.
Selecting "Setting Data: VA->PC" allows PC-set data written to the VM-3240VA to be read into the
software.
Selecting "Setting Data: PC->VA" transmits the data currently being set in the software to the VM-
3240VA.
The indication "RECEIVING COMPLETE" or "TRANSMITTING COMPLETE" is displayed on the
screen after the transmission is completed.