3-18
Chapter 3
INSTALLATION AND SETTING PROCEDURES (HARDWARE)
[IP address setting]
To set the VX-3000CT's IP address, change the IP address setting switch conguration with the following
procedures.
Notes
• Placing Switch 1 in the OFF position disables the settings performed using Switches 2 through 8.
In this case, the IP address uploaded by the VX-3000 Setting Software becomes valid.
• The IP address setting switch allows the IP address to be set only in the range of "192.168.14.111" to
"192.168.14.200". If you wish to set IP address out of this range, set it using the VX-3000 Setting Software.
(See the separate Setting Software Instructions, "UNIT DETECTION AND NETWORK SETTINGS.")
Step 1. Place Switch 1 of the IP address setting switch in
the ON position, then Switches 2 through 8 in the
positions corresponding to the desired IP address.
Step 2. (Only when the IP address has been reset after
power-on) Reactivate the VX-3000PM.
Press the VX-3000CT's Reset key to restart.
IP address setting switch
VX-3000CT rear
Reset key
VX-3000CT front
To Next Page
Loading...
