22. CHANGING THE SETTINGS
149
Inch (Fraction of an inch)
“Fraction of an inch” is the unit used in the United States and expressed like the following
example.
• Even if “inch” is selected in this setting, all the data including the result of area calculation are
output in “feet” and all the distance values must be input in “feet”. In addition, when the “inch”
display exceeds the range, it is displayed in “feet”.
Setting a password allows you to protect important information such as measurement data.
No password was set when the instrument was shipped. When setting a password for the first time,
leave the "Old password" box blank.
When a password has been set, the password screen will appear when the instrument is powered ON.
Input the password to continue.
• Password can be up to 16 characters in length. Input characters will be displayed as asterisks.
• To deactivate the password function, perform the new password setting procedure but enter a
"space" in the "New password" box.
• The password function will not be canceled when a cold boot is performed.
• The password must be input after powering ON the instrument from an external device when a
password has been set.
22.9 Changing Password
To Next Page
Loading...
Need help?
General
