42
8. POWER ON/OFF
PROCEDURE Power OFF
1. Press and hold (about 1sec) {}.
• When there is almost no battery power remaining,
the battery icon in the status bar will start to blink.In this event, stop measurement, switch off the
power and charge the battery or replace with a fully charged battery.
• To save power, power to the instrument is automatically cut off if it is not operated for a fixed period
of time. This time period can be set in "Power off" in <Inst.config.>.
"22.2 Instrument Configuration"
• In some cases, it may take longer than usual until Power OFF.
When using for the first time, or after performing a cold
boot, the screen for configuring the touch panel will be
displayed.
Follow the instructions on the screen. Tap the cross-
hairs at the center of the display with the stylus pen.
Tap 5 times. Press {ENT} to complete touch panel
configuration. Press {ESC} to retain previous settings.
For units with a display on both the F1 and F2 faces:
After tapping 5 times the display backlight will dim and
the display on the reverse face will illuminate. Tap the
cross-hairs on the reverse face display a further 5
times.
• Touch panel configuration can be performed at any time during normal operation by pressing [PNL
CAL] in <Inst.config.>.
"22.2 Instrument Configuration"
8.1 Configuring the Touch Panel
To Next Page
Loading...
Need help?
General
