22. CHANGING THE SETTINGS
141
Select a tab type from the "Type" drop-down list.
3. Repeat step 2 to perform further tab allocations.
4. Press [OK] to finish allocating tabs. The allocated
tabs are stored in memory and <Customize> is
displayed. The newly allocated tabs appear in the
relevant measurement screen.
It is possible to customize screen controls in Observation mode to suit the measurement conditions
and the different methods employed by different operators.
• The current screen control settings are retained until they are revised again, even when the power
is cut off.
•Press [CLEAR] in <Customize/Select screen> to return all customized configurations including tab
pages, status bar settings, and softkey allocations to their previous settings.
• Screen controls cannot be set for the "Graphic" tab.
• When screen control settings are recorded and registered, the previously recorded settings are
cleared.
PROCEDURE Customizing screen controls
1. Select "Customize" to display <Customize/Select
screen>.
Select the measurement mode in which you want
to customize screen controls.
22.5 Customizing Screen Controls
To Next Page
Loading...
Need help?
General
