2-7
2 PREPARATION FOR MEASUREMENT
• To correct a character, move the cursor to correct character by pressing {} or {} key and enter again.
6 Press the {F1} (NUM) key, again.
The instrument switches back to numerical input mode.
7 Enter numbers by pressing the alphanumeric characters key.
Example: { - }, {1} key is pressed.
8 Press {F4} (ENT) key.
The arrow moves to next item.
Select next character in the same manner.
PT# =TOPCON
ID :
INS.HT: 0.000 m
[ALP][SPC][CLR][ENT]
PT# =TOPCON-1
ID :
INS.HT: 0.000 m
[ALP][SPC][CLR][ENT]
To Next Page
Loading...
