16
COMPONENTS
KRT typical value style and KRT print data are R1R2
NOTE
• The reliability factor is defined with integers 1 to 9 in increasing order of
reliability. Additionally, if the reliability is high enough, the reliability factor is
not shown on the printout.
• The Near PD value is calculated based on the ADD.
• C mark appears when the button is selected by manual
operation. Adding the C mark occurs only for REF measurement values.
• ( ) mark appears when it is changed to the cataract mode automatically so
that normal measurement is not performed due to a cataract and the like.
Adding the ( ) mark occurs only for REF measurement values.
• *-mark appears when reliability of the measurement is too low.
Adding the *-mark occurs only for KRT measurement values.
1$0(
5()'$7$
ࠑ5ࠒ
6
&</
&$
9'
3'
$'' 13'
BB$0
1R
.5
6(
6(
-0.25 -0.75 90
ࠑ/ࠒ
6
&$
-0.75
-0.25+0.25 9090
.57'$7$
ࠑ5ࠒ
&251($',$
&251($',$
'
5
5
&</
$9(
$9(
&</
00 $
00 00 $
ڦڦ
ڦڦ
ڦڦ
$9(
&</
$9(
&</
$9(
&</
$9(
&</
$9(
&</
00 00 $
ڦڦ
ڦڦ
ڦڦ
723&21
ࠑ/ࠒ
'
5
5
&</
$9(
00 $
OID :
SN
&
&
&
Barcode
Work ID No.
Patient No./Patient ID
Device ID number
VD (vertex distance)
Cylinder sign
3 readings of REF right measurement
(recordable up to 10 measurements)
Typical value of right eye
Spherical equivalent of right eye
The ( ) mark appears when the mode is changed to the
cataract mode automatically during a measurement.
Pupil distance (PD value) (mm)
Near vision PD value
ADD (ordinary additional power)
Measured value of flat meridian corneal curvature
Measured value of steep meridian corneal curvature
D: Average value of corneal refractive power
MM:Average value of cornea curvature radius
Corneal astigmatic axial angle
Measured value of right eye cornea diameter (mm)
Result of refractory power
measurement (Right eye)
Result of refractory power
measurement (Left eye)
KRT data (Right eye)
KRT data (Left eye)
MM1:Corneal refractive power at flat meridian
MM2:Corneal refractive power at steep meridian
A1: Angle of flat meridian
Operator ID
Serial number
Reliability factor
C mark appears when
the mode is changed
to the cataract mode
manually during a
measurement.
*-mark appears when
reliability of the mea-
surement is too low.
To Next Page
Loading...
