39
OPTIONAL OPERATIONS
OPTIONAL OPERATIONS
DISPLAYING THE PATIENT ID (PATIENT No.) OR OPERATOR ID
A patient ID or operator ID of up to 13 characters can be input and displayed on the control panel
and printout.
However, if no patient ID is input, the patient No. is allocated automatically by the device.
1 Tap button.
2 Tap keyboard on the screen and enter characters. Tap button and fix the input value.
NOTE
• Patient ID is reset when measurement values are printed or if the
button is tapped.
• Patient No. reset condition can be selected such that the patient No. is
reset upon power on or not, in the initial setting of setup screen.
"Refer to "Patient No. reset" on page 48.
• Be sure to verify the input ID to agree with data of a patient or an operator.
To Next Page
Loading...
