48
SETTING FUNCTIONS ON SETUP SCREEN
LIST OF SETUP ITEMS
Setup items are categorized into 6 large indexes.
"Initial" .......................................items related to the initial status after power on
"Print" ........................................items related to output from the internal printer
"Comm" .....................................items related to data output with the external device
"LAN".........................................items related to output using the LAN
"Operator ID".............................items related to Operator ID
"Special" ....................................items related to maintenance (for service engineer only)
INITIAL (INITIAL SETTING)
Initial contains settings related to the initial status after power on, clearing all measurement values,
etc.
Descriptions Options Details Initial value
Buzzer sound
OFF Buzzer does not sound.
ON
ON Buzzer sounds.
Start mode
Manual Default start mode is set to Manual.
SemiAutoAutoShoot Default start mode is set to Auto Shoot.
SemiAuto Default start mode is set to Semi-Auto.
Auto print*
OFF Not printed automatically.
ON
ON After AUTO measurement, results are printed out automatically.
Printer output
OFF Internal printer is disabled.
ON
ON Internal printer is active.
Patient No. reset
OFF Patient No. is not reset upon power on.
ON
ON Patient No. is reset upon power on.
Display of patient ID
OFF Patient ID is not displayed.
OFF
ON Patient ID is displayed.
Patient ID (Mandatory)
OFF Patient ID is not displayed.
OFF
ON Patient ID is displayed.
Device ID number
1-99
Set by ten-key display.
Sets the Device ID number. 1
Display of Device ID num.
OFF Device ID is not required.
OFF
ON Device ID is required.
Start time of sleep mode
OFF Power save function is not used.
10min
1min Power save status in 1min after last operation.
5min Power save status in 5min after last operation.
10min Power save status in 10min after last operation.
20min Power save status in 20min after last operation.
30min Power save status in 30min after last operation.
60min Power save status in 60min after last operation.
Number of auto-shoot
1-10
Set by ten-key display.
The number of continuous measurements 3
Fog timing
Every time Fog timing is applied every time.
Once
Once Fog timing is applied only once before the 1st measurement.
Date/Time Set by ten-key display.
Sets year, month, day, time (24hrs),
minute and second
Installation
date/time
Sph/Cyl step
0.12 Sph/Cyl is displayed by 0.12D step.
0.25
0.25 Sph/Cyl is displayed by 0.25D step.
Axis step
1 Axial angle is displayed by 1° step
1
5 Axial angle is displayed by 5° step
VD
0.00 VD value is set to 0mm (contact lens).
13.75*12.00 VD value is set to 12.00mm (eyeglass lens).
13.75 VD value is set to 13.75mm (eyeglass lens).
To Next Page
Loading...
