Topcon KR-800A - Basic Operations; Preparation before Measurement; Turning on the Instrument; Selecting the Measurement Mode

22
BASIC OPERATIONS
BASIC OPERATIONS
PREPARATION BEFORE MEASUREMENT
BASIC OPERATIONS
PREPARATION BEFORE MEASUREMENT
TURNING ON THE INSTRUMENT
1 Insert the power cable plug into the commercial power (the 3-pin AC grounding receptacle).
For the details of connection, refer to "CONNECTING POWER CABLE" on page 18.
2 Press on the switch.
3 Make sure that the title screen is displayed and then the MEASUREMENT screen is displayed
in a few seconds.
SELECTING THE MEASUREMENT MODE
This product has three measurement modes: R/K (REF/KRT continuous measurement), KRT (KRT
single measurement) and REF (REF single measurement).
1 Check that the MEASUREMENT screen is on.
2 Tap the button on the control panel and select the measurement
mode.
Indication of the but-
ton is changed.
REF:Only REF measurement
KRT:Only KRT measurement
R/K: REF/KRT continuous measurement
POWER
MEASUREMENT MODE
Pa
tientI
D
PatientID
0/3
0/3
0/3
0/3
12.
12.
0/3
0/3
0/3
0/3

1
1
R
R
S
SS
C
C
A
A
K
K
R1
R1R1
R2
R2R2
A1
A1A1
R
R
S
S
C
C
A
A
K
K
R1
R1R1
R2
R2R2
A1
A1A1
VD
VDVD
mm
mm
TOPCONTAROU
TOPCONTAROU
mm
mm
Semi Auto
MEASUREMENT MODE