56
MAINTENANCE
HOW TO CLEAN THIS INSTRUMENT
CLEANING THE FOREHEAD REST AND CHIN REST
Wipe the forehead rest and the chin rest with a cloth moistened with a tepid solution of neutral deter-
gent for kitchenware.
CLEANING THE KERATO RING AND THE COVER
1 If the kerato ring and the cover get soiled, wipe the surface with dry cloth.
2 If the kerato ring and the cover are noticeably stained, wipe the surface with a damp cloth which
is moistened in a tepid water solution of neutral detergent.
CLEANING THE CONTROL PANEL
CONTAMINATION BY DUST
Remove the dust with a soft brush, and wipe with the attached monitor cleaner.
CONTAMINATION BY FINGERPRINTS
Wipe with the attached monitor cleaner.
If the stain still remains, moisten the monitor cleaner with water and then wipe off the stain.
CLEANING THE MEASURING WINDOW
• Dust on measuring window... Blow off dust with a blower.
• Fingerprints and oil spots on measuring window
...... Blow off dust by a blower and wipe the surface gently with a camera lens
cleaner using clean gauze.
NOTE
Do not clean plastic parts with solvents.
Benzine, thinner, ether, gasoline and chemical duster may cause discoloring
and decomposition.
NOTE
• As the control panel screen is a touch panel, be sure to turn off the
POWER switch before wiping. The touch panel will react and malfunction.
• When the monitor cleaner has become dirty, wash it. When washing, rinse
it thoroughly so no detergent is left. If the detergent is left, it may cause
uneven wiping.
To Next Page
Loading...
