Topcon KR-800A - Page 51

49
SETTING FUNCTIONS ON SETUP SCREEN
Descriptions Options Details Initial value
ADD
NO
40-44
45-49
50-54
55-59
60-64
65-69
70-74
The typical additional power for the age can be selected. NO
D or mm(KRT)
D D (diopter) of corneal refractive power
mm
mm mm of corneal curvature
HV or R1R2
HV
Corneal curvature radius measurement result
on screen is displayed by HV
R1R2
R1R2
Corneal curvature radius measurement result
on screen is displayed by R1R2(flat/steep meridian).
Display of KRT unit
OFF KRT unit is not shown.
ON
ON KRT unit is shown.
Cylinder sign
- Cylinder sign is " - ".
- + Cylinder sign is "+".
MIX Cylinder sign is "+" and "
- ".
Measure mode setting
REF Default measurement mode is REF.
REF/KRTREF/KRT Default measurement mode is R/K.
KRT Default measurement mode is KRT.
R/L or OD/OS
R/L Right/left eyes is displayed by R/L.
R/L
OD/OS Right/left eyes is displayed by OD/OS.
Control panel brightness
Level 1 (dark)
The brightness of control panel. Level 4
Level 2
Level 3
Level 4 (bright)
Display of REF average
OFF REF average is not displayed.
OFF
ON REF average is displayed.
Packing mode Execute This instrument is set to the condition for packing.
-
Use original IPA font
OFF
A line of the frame is shown to the character
of the measurement values, etc.
OFF
ON
A line of the frame disappears in the character
of the measurement values, etc.
Eyelid fuction
OFF The eyelid function is invalidated.
ON
ON The eyelid function is made effective.
Eyelid Force Meas. time
0-99
Set by ten-key display.
The time until measurement is forcibly begun
is set after eyelid detection message is displayed.
99
Inspection mode
OFF Inspection mode is released.
OFF
ON Inspection mode is set to measure model eye.
SCA display type
SIMPLE
When the measurement results of the spherical refractive-power
(S) and cylindrical refractive power (C) are over 0, the plus sign
(+) is not displayed. When the cylindrical refractive power is at
0D, the values of cylindrical refractive power and the direction of
astigmatic axis (A) are not displayed.
SIMPLE
ALL
When the measurement results of the spherical refractive-power
(S) and cylindrical refractive power (C) are over 0, the plus sign
(+) is displayed. When the cylindrical refractive power is at 0D,
the cylindrical refractive power is displayed at 0.00 and the direc-
tion of astigmatic axis (A) is displayed at 0.