Operator’sConsole
g351974
Figure101
1.Operator’sconsole
7.Knob
2.Flatwasher(7each)
8.Dashpanelassembly
3.Capscrew(7each)
9.Carboncanister
4.Lockwasher(3each)10.Locknut(4each)
5.Flatwasher(4each)11.Consolesupportplate
6.Capscrew(4each)12.Carboncanisterbracket
RemovingandInstallingtheOperator’sConsole
RefertoFigure101forthisprocedure.
1.Parkthemachineonalevelsurface,loweranyattachments,engagethe
parkingbrake,setthekeyswitchtotheOFFpositionandremovethekey
fromtheswitch.
2.Removetheknob(s)fromtheliftcontrolvalvelever(s).
3.Removethefastenerssecuringthedashpaneltotheconsole.Raisethedash
panelanddisconnectthewireharnessfromthehourmeterandtheoptional
PTOswitch,thenremovethedashpanelassemblyfromthemachine.
4.Pressthetangofthecarboncanisterbracketupwardandslidethecarbon
canisterforwardandoutofthebracket.
5.Removethe3capscrews,lockwashersandatwashersthatsecurethe
consoletotheframeandremovetheoperator’sconsolefromthemachine.
Note:Theconsolesupportplateisfastenedtotheconsole.
6.Installtheoperator’sconsoleinthereverseorder.
Chassis:ServiceandRepairs
Page7–24
SandPro
®
3040and5040
20251SLRevA
To Next Page
Loading...
