Reelmaster 5200-D/5400-D Hydraulic SystemPage 4 - 79
Reassembly
1. Make sure all parts are clean before reassembly.
2. Coat new O-rings, Uni-rings, rod seal, back-up ring,
and dust seal with with clean hydraulic oil.
A. Install Uni-ring and O-ring to the piston.
B. Install dust seal, O-ring, back-up ring, and dust
seal to the head.
IMPORTANT: Do not clamp vise jaws against the
shaft surface. Protect shaft surface before mount-
ing in a vice.
3. Mount shaft securely in a vise by clamping on the cle-
vis of the shaft.
A. Coat shaft with with clean hydraulic oil.
B. Slide head onto the shaft. Install rod seal onto
shaft and into head.
Hydraulic
Systems
To Next Page
Loading...
