Toro Reelmaster 5200-D - Page 122

Rev. A
Reelmaster 5200-D/5400-DHydraulic System Page 4 - 78
Lift Cylinder Service
1. Barrel with clevis
2. Nut
3. Uni-ring
4. Piston
5. O-ring
6. Rod seal
7. O-ring
8. Back-up ring
9. Head
10. Dust seal
11. Collar
12. Shaft with clevis
13. Grease fitting
Figure 99
FRONT LEFT AND FRONT RIGHT
LIFT CYLINDER
FRONT CENTER
LIFT CYLINDER
REAR
LIFT CYLINDER
10
7
3
5
8
6
11
12
1
13
2
4
9
10
7
3
5
8
6
11
12
1
13
2
4
9
10
7
3
5
8
6
11
12
1
13
2
4
9
Disassembly
1. Remove oil from lift cylinder into a drain pan by slowly
pumping the cylinder shaft. Plug both ports and clean
the outside of the cylinder.
IMPORTANT: Prevent damage when clamping the
cylinder’s barrel into a vise; clamp on the clevis
only. Do not close vise enough to distort the barrel.
2. Mount lift cylinder into a vice. Remove collar with a
spanner wrench.
3. Extract shaft, head, and piston by carefully twisting
and pulling on the shaft.
IMPORTANT: Do not clamp vise jaws against the
shaft surface. Protect shaft surface before mount-
ing in a vice.
4. Mount shaft securely in a vise by clamping on the cle-
vis of the shaft. Remove lock nut and piston from the
shaft. Slide head off the shaft.
5. Remove Uni-ring and O-ring from the piston. Re-
move O-ring, back-up ring, rod seal, and dust seal from
the head.