Toshiba E-STUDIO4508A - 13. EXTERNAL COUNTERS; 13.1 Outline; 13.2 Signal; 13.2.1 Pin Layout

13
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
EXTERNAL COUNTERS
13 - 1
13. EXTERNAL COUNTERS
13.1 Outline
This specification describes the interface between external counters, such as Coin Controller and Card
Counter.
13.2 Signal
13.2.1 Pin Layout
1. Connector on the LGC board: CN313 (Coin Controller)
* FLCTR signal is exclusively for color copy and not provided for this equipment.
Pin
No.
I/O
Signal
name
Function Voltage level Remarks GQ-1260
A1 Power +24VD1 24V line DC24V±10% When cover
opened: OFF
In use
A2 Out CTRON Total Counter On Signal Open Collector
(M63830)
L: ON In use
A3 In KCTRC Counter Connection
Signal
L=0V, H=DC5V L: Connected
H: Not connected
-
A4 Out MCRUN Ready to Copy Signal Open Collector
(SN7407)
L: Operating
H: Stop
In use
A5 Out EXTCTR Exit Sensor On Signal
(Exit Counter On Signal)
Open Collector
(SN7407)
L: ON In use
A6 GND PG Power ground 0V In use
A7 Out CSTCTR Drawer paper feed
counter On signal (Front
side of paper print
counter)
Open Collector
(SN7407)
L: ON -
A8 Out ADUCTR ADU paper feed counter
On signal (Back side of
paper print counter)
Open Collector
(SN7407)
L: ON -
B1 Out FLCTR Color counter On signal
(Unused)
Open Collector
(SN7407)
L: ON -
B2 GND SG Signal Ground 0V -
B3 Out TSIZE3 Paper size Signal Open Collector
(SN7407)
L: ON -
B4 Out TSIZE2 Paper size Signal Open Collector
(SN7407)
L: ON -
B5 Out TSIZE1 Paper size Signal Open Collector
(SN7407)
L: ON -
B6 Out TSIZE0 Paper size Signal Open Collector
(SN7407)
L: ON -
B7 Power +5VB 5V line DC5.1V±5% At the sleep mode:
OFF
In use
B8 In- CTRCNT2 Counter enabled signal L=0V, H=DC5V L: Enabled
H: Disabled
In use