Toshiba E-STUDIO4508A - 8.3.20 Offset tray related service call

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 218
8.3.20 Offset tray related service call
[CDF0] Initialize error of the offset tray (e-STUDIO206L/256/306 / 207L/257/307)
[CDF0] Initialize error of the offset tray (e-STUDIO356/456/506 / 357/457/507)
Classification Contents
Offset tray related service call Initialize error of the offset tray
Check Item Measure
OCT motor
OCT board
LGC board
1. Check if each connector between the OCT motor and OCT
board (CN261) is disconnected.
2. Check if each connector between the OCT board (CN261)
and LGC board (CN302) is disconnected.
3. Check if each connector pin is removed or the harness is
broken.
4. Check if any conductor pattern on the OCT board and LGC
board is short circuited or open circuited.
Replacement part Measure
OCT motor
OCT board
LGC board
Classification Contents
Offset tray related service call Initialize error of the offset tray
Check Item Measure
Offset gate motor
MOT2 board
LGC board
1. Check if each connector between the offset gate motor and
MOT2 board (CN406) is disconnected.
2. Check if each connector between the MOT2 board (CN406)
and LGC board (CN302) is disconnected.
3. Check if each connector pin is removed or the harness is
broken.
4. Check if any conductor pattern on the MOT2 board and LGC
board is short circuited or open circuited.
Replacement part Remark
Offset gate motor.
MOT2 board
LGC board