e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 180
4.13.5 KN-5005 (Bridge Kit)
(13) Lift the equipment up and remove the large
capacity feeder.
Fig. 4-489
(1) Press the [Power] button on the control panel
to shut it down.
(2) Turn the main power switch of the equipment
off.
(3) Disconnect the power cable.
(4) Remove the connecting port cover.
(5) Disconnect 1 connector.
Fig. 4-490
(6) Remove 1 screw and take off the front cover
of the bridge kit.
Fig. 4-491
To Next Page
Loading...
