9
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
REPLACEMENT OF PC BOARDS/HDD
9 - 35
9.2.11 License re-registration using the one-time dongle
[ 1 ] Re-registration when the board is replaced
The license registered using the one-time dongle can be re-registered only in the same equipment.
When the SYS board or FRAM is replaced, follow the procedures for re-registration given below.
(1) Performs FS-08-3840.
(2) Press the [INSTALL].
(3) Install the one-time dongle in the equipment (the one which you used for registering the selected
license), and then press the [OK].
(4) Select the license to be installed, and then press the [INSTALL].
(5) The screen for notifying that the installation will be started is displayed. Then press the [YES].
(6) After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK]. If the screen for notifying a failure of the performance is
displayed, quit this operation by pressing the [CLOSE]. Then check that the one-time dongle,
which you used for uploading the selected license, is installed in the equipment.
(7) Check that the installed license is displayed on the license list.
Remarks:
If there are any other licenses to be returned, repeat from step (2). If there are no other licenses
to be returned, press the [CLOSE], and then turn the power OFF.
Notes:
This procedure is available only with the one-time dongle used for the previous registration, since
the model information registered in it is utilized. Use the same one-time dongle and the
equipment when registering the license.
[ 2 ] Re-registration when the equipment is replaced due to malfunction
When the equipment has to be replaced due to a malfunction, return the license registered in the
equipment to the one-time dongle and register it to the new equipment following the procedure below.
Notes:
The license of the IPSec Enabler (GP-1080) cannot be reinstalled. The one-time dongle to be
used is the one for the previous registration of the license. The license is deleted from the
equipment and is stored in the one-time dongle.
Do not perform the deletion of Converter for PDF-Archive since it is deleted without any return to
the one-time dongle.
(1) Performs FS-08-3840.
(2) Select the license to be returned, and then press the [REMOVE].
(3) Install the one-time dongle in the equipment (the one which you used for uploading the selected
license), and then press the [OK].
(4) The Remove screen is displayed. Then press the [YES].
If this screen is not displayed, check that the one-time dongle is installed in the equipment
properly.
To Next Page
Loading...
