e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
REPLACEMENT OF PC BOARDS/HDD
9 - 36
(5) After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK].
If the screen for notifying a failure of the performance is displayed, quit this operation by pressing
the [CLOSE]. Then check that the one-time dongle, which you used for uploading the selected
license, is installed in the equipment.
(6) Check that the returned license is not displayed on the screen.
Remarks:
If there are any other licenses to be returned, repeat from step (2).
If there are no other licenses to be returned, press the [CLOSE], and then turn the power OFF.
(7) Replace the equipment.
(8) Performs FS-08-3840.
(9) Press the [INSTALL].
(10) Install the one-time dongle in the equipment (the one which you used for returning the selected
license before replacing the equipment). Then press the [OK].
(11) Select the license to be installed, and then press the [INSTALL].
(12) The screen for notifying that the installation will be started is displayed. Then press the [YES].
(13) After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK]. If the screen for notifying a failure of the performance is
displayed, quit this operation by pressing the [NO] button. Then check that the one-time dongle is
installed properly in the equipment.
(14) Check that the installed license is displayed on the license list.
Remarks:
If there are any other licenses to be installed, repeat from step (9). If there are no other licenses
to be installed, press the [CLOSE], and then turn the power OFF.
To Next Page
Loading...
