Toshiba E-STUDIO4508A - 6.16 Adjustment of Hole punch unit; 6.16.1 Destination setting of hole punch control PC board

6
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SETTING / ADJUSTMENT
6 - 99
6.16 Adjustment of Hole punch unit
6.16.1 Destination setting of hole punch control PC board
This setting is performed when the hole punch control PC board (HP) [1] is replaced with a DIP switch
[2] on it.
Fig.6-109
Refer to the table below for the destination settings.
Destination Number of punch holes
DIP switch
12
MJ-6007E (Europe/Japan/China) 2 holes OFF OFF
MJ-6007N (North America) 2/3 holes ON OFF
MJ-6007F (France) 4 holes OFF ON
MJ-6007S (Sweden) 4 holes ON ON
1 2
ON
[2] [1]