e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 92
6.15.3 Stapling/folding position adjustment in saddle stitch unit
Perform this adjustment when the saddle control PC board was replaced or the stapling/folding position
must be changed for some reason.
Prepare 2 types of booklet samples using the main unit and use them for adjustment accordingly.
(1) Create 2 types of booklet samples (1 set each) using the main unit.
(2) Measure the stapling and folding positions of the samples, and then perform adjustment
accordingly.
For stapling and folding, paper on the stacker of the stacker unit is moved to an exclusive
mechanism for stapling or folding. Therefore adjustment must be performed individually for the
folding stopping position of the stacker and the stapling stopping position.
*Check the folding position at the centerfold page of the sample.
Fig.6-96
* Check the stapling position at the centerfold page of the sample.
Fig.6-97
Sample 1 Sample 2
Media type Recommended paper Recommended paper
Paper size A4 A3
Number of sheet 5 sheets 5 sheets
Paper exit
direction
Center
fold
page
-2mm - +2mm
-2mm - +2mm
Do not include the
width of the staples
Staple
When the staples are bent
-0.5mm - +0.5mm
-0.5mm - +0.5mm
Folding lineFolding line
Staple
To Next Page
Loading...
