Toshiba E-STUDIO4508A - 4.10 Fuser Unit; 4.10.1 Fuser unit

4
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
DISASSEMBLY AND REPLACEMENT
4 - 121
4.10 Fuser Unit
4.10.1 Fuser unit
Notes:
• Be sure that the temperature of the fuser unit has lowered enough before removing it.
If the unit still heated should be removed, wear a pair of gloves before working.
• When a new fuser unit is installed, be sure to check whether the fuser-related life counter
values have been cleared in the list printing mode or the setting mode (08).
• When disassembling the fuser unit or replacing any parts in it, be sure that the wire harness is
correctly set, and also be careful not to catch it between other parts.
(1) Open the side cover.
(2) Press down the lever [1] and remove the
fuser unit [2].
Notes:
• The fuser unit is extremely hot. When
removing the fuser unit, hold the handles
of the unit to avoid a direct touch on the
unit.
Fig. 4-327