e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
5 - 12
5.6 [05 ADJUSTMENT MODE]
Various adjustments and test printing can be performed.
5.6.1 Adjustment
<Operation procedure>
• [05] indicates that the equipment is shifted to the [CLASSIC] mode after [05 ADJUSTMENT MODE]
is selected.
• The procedure indicated by the dotted lines should be performed when a check using a printout is
required.
Procedure 1
* Press [FUNCTION CLAER] to enter minus (-).
Procedure 2
Procedure 3
Procedure 4
* Press [FUNCTION CLAER] to enter minus (-).
[
START
]
[
Test copy
]
[05]
[FS]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[START]
[CANCEL]
[Digital key]
*
[FUNCTION CLEAR]
(Key in a value)
[CLEAR]
(Corrects value)
[OK]
(Stores value in RAM)
[05]
[FS]
[START]
[Test copy]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[START]
[OK]
(Value unchangeable)
Value
displayed
()
[05]
[FS]
[START]
[
Test copy]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[START]
[CANCEL]
[UP]
or
[DOWN]
(Adjust a value)
[FUNCTION CLEAR]
(Corrects value)
[OK]
(Stores value in RAM)
[05]
[FS]
[
START
]
[
Test copy
]
[Digital key]
(Code)
[Digital key]
(Sub code)
[CLEAR]
(Corrects value)
[OK]
[CANCEL]
[START]
[START]
[START] [Digital key]
*[FUNCTION CLEAR]
(Key in a value)
[CLEAR]
(Corrects value)
Stores value
in RAM
[POWER]
OFF/ON
(Exit)
To Next Page
Loading...
