e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 28
(4) Remove 2 screws from the frame holes [2].
Fig. 4-72
(5) Remove the flat cable [4] from the carriage-1
[1].
(6) Remove the flat cable [4] from the harness
guide [5].
Fig. 4-73
(7) Slide the front of the carriage-1 [1] toward the
direction of the arrow shown in the figure,
while trying not to touch the mirror [6]. Then
remove the carriage-1 [1].
Fig. 4-74
To Next Page
Loading...
