Toshiba E-STUDIO4508A - Page 396

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 12
[E] Primary scanning data laser writing start position at duplexing
Notes:
Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.
[E-1] Adjustment for long-sized paper
<Procedure>
(1) Performs FS-05.  (05 Adjustment Mode)
(2) Press [3]  [TEST PRINT]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from
the lower drawer (Refer to *).
(3) Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
(4) Check if the distance E is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance E again.
FS-05  Key in code [4019]  [START]  [0]  [START]
 (Key in a value (acceptable values: 0 to 255))
 [OK] (Stored in memory)
 “100% A” is displayed.
 Press [3]  [TEST PRINT](A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance E becomes (approx. 0.0423 mm/
step).
[E-2] Adjustment for short-sized paper
<Procedure>
(1) Performs FS-05.  (05 Adjustment Mode)
(2) Press [3]  [TEST PRINT]. (A grid pattern with 10 mm squares is printed out. Use A4/LT from
the upper drawer.)
(3) Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
(4) Check if the distance E is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance E again.
FS-05  Key in the code [4019]  [START]  [1]  [START]
 (Key in a value (acceptable values: 0 to 255))
 [OK] (Stored in memory).
 “100% A” is displayed
 Press [3]  [TEST PRINT]  (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance E becomes (approx. 0.0423 mm/
step).