e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 60
(4) Position the pins with the holes on the RADF
by moving it so that the pins fit into the holes
when the RADF is closed.
Fig.6-54
(5) Tighten the left-hand hinge screw at the rear
side.
Fig.6-55
(6) Loosen the hole position adjustment screws
on the right hand side. (MR-3021/3022)
Fig.6-56
(7) Match the screw hole positions.
Fig.6-57
To Next Page
Loading...
