e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 88
(5) Press the [Button1] to adjust the alignment position.
Every time the [Button1] is pressed, the alignment plate shifts 1 step (0.419 mm/step) toward the
“+ “direction. (The gap between the alignment plates becomes narrower.)
Adjustment range is from -5 to +5 steps.
If the [Button1] is pressed when the alignment position is at the “+5 step”, the plate will return to
the home position and then moves to the position of “-5 step”.
Fig.6-92
(6) Place the adjustment sheet [1] on the process tray and adjust the position to make the gap
between paper and the alignment plate [2] “0”.
Then setting is performed at a value that is one smaller than the adjustment value.
Fig.6-93
Remarks:
• Use an adjustment sheet [1] made of plastic resin which is light and accurate in measurement
(e.g. OHP film).
• To reduce frictional resistance with the vertical alignment roller [3] on the process tray, place a
sheet of B5 paper [4] beneath the adjustment sheet [1] on the vertical alignment roller [3].
• Confirm the gap between paper and the alignment plate [2] by moving the adjustment sheet
[1] forward and backward to reduce affect by backlash of the gear of the side alignment plate.
LED3 LED2 LED1
Button2Button1
To Next Page
Loading...
