e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
PREVENTIVE MAINTENANCE (PM)
7 - 44
*q Grate-shaped guide
After the grate-shaped guide [1] is cleaned with alcohol, use a cleaning brush to apply coating
material (SANKOL CFD-409M) on the part with which the paper edge is in contact.
*Use a cleaning brush (4407915710 BRUSH-33) because cloth contaminated with the coating
material shall be treated as industrial waste.
*Do not apply coating material (Molykote PD-910) to the rubber section of the grate-shaped tray.
*When coating material adheres to the skin, rinse it well with water.
Fig. 7-42
To Next Page
Loading...
