Toshiba E-STUDIO4508A - Page 624

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 86
[E130] Upper drawer misfeeding (paper not reaching the 1st transport sensor)
Classification Error content
Paper misfeeding Jam not reaching the 1st transport sensor
Proce
dure
Check item Result Measure
Next
Step
1
Open the Automatic
duplexing unit. Is there
any paper in front of the
1st transport sensor?
Yes Remove the paper.
No
2
2
Is the 1st transport sensor
working?
(Perform the input check
in the test mode: 03-
[FAX]OFF/[6]/[A])
Yes
3
No • Check if the connector of the 1st transport
sensor is disconnected.
• Check if the connector CN316 on the LGC
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor pattern on the LGC
board is short circuited or open circuited.
• Replace the 1st transport sensor.
• Replace the LGC board.
3
Is the upper drawer feed
clutch working?
(Perform the output check
in the test mode: 03-201)
Yes
4
No • Check if the connector of the upper drawer
feed clutch is disconnected.
• Check if the connector CN315 on the LGC
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor pattern on the LGC
board is short circuited or open circuited.
• Replace the upper drawer feed clutch.
• Replace the LGC board.
4
Upper drawer feed roller
Separation roller
• Check the upper drawer feed roller,
separation roller and pickup roller.
Replace them if they are worn out.
Parts to be replaced Remark
1st transport sensor.
LGC board
Upper drawer feed clutch
Upper drawer feed roller
Separation roller
Pickup roller