e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 96
[E450] LCF side cover opened during printing
Classification Error content
Cover open jam LCF side cover open jam
Proce
dure
Check item Result Measure
Next
Step
1
Is the LCF side cover
open?
Yes Remove the paper if there is any, then close
the cover.
No
2
2
Is the LCF side cover
opening/closing switch
working?
(Perform the input check
in the test mode: 03-
[FAX]OFF/[4]/[B])
Yes
3
No • Check if the connector of the LCF side
cover opening/closing switch is
disconnected.
• Check if either of the connectors CN1 or
CN7 on the LCF board is disconnected.
• Check if the connector CN318 on the LGC
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor patterns on the LCF
board and LGC board are short circuited or
open circuited.
• Replace the LCF side cover opening/
closing switch.
• Replace the LCF board.
• Replace the LGC board.
3
Replacing board • Replace the LCF board.
• Replace the LGC board.
Parts to be replaced Remark
LCF side cover opening/closing
switch
LCF board
LGC board
To Next Page
Loading...
