8
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8 - 113
[ 2 ] Job separator jam
[E950] Jam not reaching the JSP feed sensor
[E951] Stop jam at the JSP feed sensor
Classification Error content
Job separator jam Jam not reaching the job separator transport sensor
Stop jam at the job separator transport sensor
Proce
dure
Check item Result Measure
Next
Step
1
Open the JSP cover. Is
there any paper on the
transport path?
Yes Remove the paper.
No
2
2
Is the JSP feed sensor
working?
(Perform the input check
in the test mode: 03-
[FAX]ON/[3]/[D])
Yes
3
No • Check if the connector of the JSP feed
sensor is disconnected.
• Check if either of the connectors CN260 or
CN262 on the JSP board is disconnected.
• Check if the connector CN302 on the LGC
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor patterns on the JSP
board and LGC board are short circuited or
open circuited.
• Replace the JSP feed sensor.
• Replace the JSP board.
• Replace the LGC board.
3
Replacing board • Replace the JSP board.
• Replace the LGC board.
Parts to be replaced Remark
JSP feed sensor
JSP board
LGC board
To Next Page
Loading...
