8
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8 - 131
[EA70] Stack exit belt home position error / Stack slider home position error
MJ-1101/1107
MJ-1106/1108
Parts to be replaced Remark
Entrance sensor
Finisher controller PC board
Classification Error content
Paper jam in finisher section Stack exit belt home position error / Stack slider home position error
Check item Measures
Stack belt exit home position
sensor
Check if the connector CN11 on the finisher controller PC board is
disconnected from the stack belt exit home position sensor (S9) and
the harnesses are open circuited. Correct if any.
Stack transport motor Is the harness between the stack transport motor (M5) and the
finisher control PC board (CN10) disconnected or open circuited?
Parts to be replaced Remark
Stack belt exit home position
sensor
Stack transport motor
Finisher controller PC board
Check item Measures
Stack belt exit home position
sensor
Check if there is a disconnection of the connector, incorrect
installation or breakage of the stack belt exit home position sensor
(S9). If there is, reinstall the sensor correctly or replace it.
Check if the connector (CN18) on the finisher controller PC board is
disconnected from the stack belt exit home position sensor (S9) and
the harnesses are open circuited. Correct if any.
Stack transport motor Check if the connector (CN17) on the finisher controller PC board is
disconnected from the stack transport motor (M8) and the
harnesses are open circuited. Correct if any.
Parts to be replaced Remark
Stack belt exit home position
sensor
Stack transport motor
Finisher controller PC board
To Next Page
Loading...
