3
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
OUTLINE OF THE MACHINE
3 - 25
(C) Set key copy counter
(D) Misfeed in equipment ( )
Clear paper symbol is displayed ( ): E120
Copying operation is disabled
Solution: The bypass paper sensor is turned OFF by removing the paper from the bypass tray.
• When the key copy counter (optional) is pulled out from the equipment which installs it:
“Set key copy counter” displayed
Copying operation disabled
• When the counter is pulled out during copying:
Copying is stopped when the key copy counter is pulled out.
“Set key copy counter” displayed
Copying operation disabled
• Exit sensor detects jamming of the leading edge of paper.
Registration clutch ON
Fig. 3-12
Less than regulation time
Exit sensor ON
If the exit sensor is not turned ON after the
regulation time
Paper jam (E010) The copying operation
is stopped
• Exit sensor detects jamming of the tailing edge of paper
Registration clutch
Exit sensor
Timer
0
Paper jam (E010)
ON
ON
Regulation time
To Next Page
Loading...
