e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 208
[CC51] Punch unit sliding motor (M12) abnormality
MJ-1032
[CC51] Punch unit sliding motor (M16) abnormality
MJ-1033
Replacement part Measure
Sideways adjustment motor (M2)
Hole punch control PC board (HP)
Sideways deviation home position
sensor (S3)
Error Timing of detection
Punch unit sliding motor (M12)
Punch sliding unit home position
sensor (S23)
The punch sliding unit is not slid after sliding request is sent.
The punch sliding unit home position sensor (S23) does not detect that
the unit is at its home position after the specified time when the unit is
returned to the home position, or this sensor does not detect that the
unit is out of its home position after the specified time when the unit is
released.
The punch sliding unit home position sensor (S23) does not detect that
the unit is at its home position after the specified time when the unit is
moved, or this sensor does not detect that the unit is at its home
position when the unit is released.
Probable cause Checking and measures
Punch unit sliding motor (M12)
abnormality
Check if the electrical continuity of the coil is normal. If electricity is not
conducted, replace the motor.
Punch sliding unit home position
sensor (S23) abnormality
Measure the voltage on TP26 on the hole punch control PC board
(HP). Then check that the measured voltage is 1V or lower when not
shielded and within the range of 5V5% when shielded. If the voltage
does not fall within the range mentioned, replace the sensor.
Faulty cables and connectors Check if the electrical continuity between the connector terminals is
normal. If electricity is not conducted, replace the connector. (Hole
punch control PC board (HP): CN3, CN5, CN6)
Hole punch control PC board (HP)
abnormality
If the error still occurs after replacing the motor, sensor and
connectors, exchange the hole punch control PC board (HP).
Error Timing of detection
Punch unit sliding motor
Punch sliding unit home position
sensor
The turning OFF of the punch sliding unit home position sensor
(S37) is not detected when the punch unit sliding motor (M16) is
driven for the specified distance while this sensor is ON.
The turning ON of the punch sliding unit home position sensor
(S37) is not detected when the punch unit sliding motor (M16) is
driven for the specified distance in the same direction as the
ON direction of this sensor while returning to its home position
Probable cause Checking and measures
Punch unit sliding motor (M16)
abnormality
Check if the electrical continuity of the coil is normal. If
electricity is not conducted, replace the motor.
Punch sliding unit home position
sensor (S38) abnormality
Measure the voltage on pin CN5.3 on the hole punch control
PC board (HP). Then check that the measured voltage is 1V or
lower when not shielded and within the range of 5V5% when
shielded. If the voltage does not fall within the range mentioned,
replace the sensor.
To Next Page
Loading...
