e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
REPLACEMENT OF PC BOARDS/HDD
9 - 2
Notes:
• When removing the flat cable [3], change the
lever position so that the connector is
released, and remove the flat cable by lifting
it up slightly (approx. 7 degrees) as shown in
the right figure.
• When connecting the flat cable [3] to the
connector, insert the flat cable straightly and
lock it securely. Confirm that the tabs are in
the positions shown in the right figure.
Fig. 9-3
Notes:
• When installing the flat cable [3], do not push
it in strongly.
• When installing the flat cable [3], be careful
not to insert it at an angle.
• Do not apply pressure to or damage the
edge of the flat cable [3].
Fig. 9-4
(6) Disconnect 10 connectors from the SYS
board. Remove 2 flat cables [4].
Fig. 9-5
To Next Page
Loading...
