Toshiba e-Studio477s - Early Arrival Jam; Paper Jam in Finisher Section; Paper Not Detected; Paper Transport Jam

© 2013-2016 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO477S/527S/477SL
ERROR CODE AND TROUBLESHOOTING
5 - 29
5
5.3.2 Paper jam in finisher section
[EA10] Paper not detected
[EA20] Early arrival jam
[EA26] Paper transport jam (stop command request)
Classification Error content
Paper jam in finisher section Paper was not detected at the finisher within the set period after the
paper was fed by the main unit.
Check item Measures
Entrance transport sensor • Sensor check (S1)
• Connector check (P7-2)
• Harness check
Finisher control PC board • Board check
• Connector check (J7)
• Harness check
Parts to be replaced Remark
Entrance transport sensor
Finisher control PC board
Classification Error content
Paper jam in finisher section A sheet of paper is fed and then the next sheet of paper is fed at an
interval shorter than the specified time.
Check item Measures
Transport path If there is paper in the paper transport path, remove the paper.
Entrance transport sensor • Sensor check (S1)
• Connector check (P7-2)
• Harness check
Exit transport sensor • Sensor check (S2)
• Connector check (P8-1)
• Harness check
Finisher control PC board • Board check
• Connector check (J7,J8) J7: input, J8: output
• Harness check
Parts to be replaced Remark
Entrance transport sensor
Exit transport sensor
Finisher control PC board
Classification Error content
Paper jam in finisher section Main unit requested finisher to stop operating while finisher was
feeding paper.
Check item Measures
Transport path If there is paper in the paper transport path, remove the paper.