© 2013-2016 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO477S/527S/477SL
ERROR CODE AND TROUBLESHOOTING
5 - 71
5
[F700] Overwrite error
[F800] Date error
[F900] Model information error
Classification Error item
Other service call Overwriting fails.
Check item Measures
Setting •
If a service call occurs again after the reboot, replace the HDD.
Classification Error item
Other service call The year 2038 problem
Check item Measures
Setting Reset the date, and request the administrator to set the date
and time.
1. Turn the power on while pressing the [6] and [CLEAR]
button.
2. Select [2] key, and then press the [START] button.
3. Press the [START] button on the confirmation screen
displayed. (The date is set to January 1st, 2011.)
4. Request the administrator to set the date and time.
Classification Error item
Other service call Machine information alignment error. The machine
information is damaged.
Check item Measures
Setting Recover the machine information by means of the following
procedure.
<Machine information recovery>
1. Turn the power ON while pressing [6] and the [CLEAR]
button simultaneously.
2. Key in [3] to select "3. SRAM Re-Initialize Support", and
then press the [START] button.
3. Select the proper machine information with 1 or 2 key, and
then press the [START] button.
4. Shut down the equipment by pressing the [ON/OFF]
button.
5. Turn the power ON by pressing the [ON/OFF] button.
* If it is not recovered, initialize the SRAM by performing the
following procedure.
P. 6-22 "6.2.5 Precautions and procedure when replacing
the SRAM board (for the SYS board)"
To Next Page
Loading...
